Call Mobile Client From Device; Call Room From Device - HIKVISION Ultra Series User Manual

Note
For details about adding device, see Add Device.
5. Link a user to an indoor station and set a room No. for the indoor station.
6. Call the room.
- If you have configured a specified room No. in the Basic Settings , you can tap
room.
- If you have not configured a specified room No. in the Basic Settings , you should tap
the authentication page of the device. Enter the room No. on the dial page and tap
the room.
7. After the indoor station answers the call, you can start two-way audio with the indoor station.

7.12.5 Call Mobile Client from Device

Steps
1. Get the mobile mobile client from the supplied disk or the official website, and install the
software according to the prompts.
2. Run the mobile client and add the device to the mobile client.
Note
For details, see the user manual of the mobile client.
3. Enter Basic Settings → Shortcut Key and enable Call APP.
4. Go back to the initial page and call the mobile client.
1) Tap on the device initial page.
2) Tap to call the mobile client.

7.12.6 Call Room from Device

Steps
1. Get the client software from the supplied disk or the official website, and install the software
according to the prompts.
2. Run the client software and the control panel of the software pops up.
3. Tap on the device initial page.
4. Enter the room No. , and tap call button.
Face Recognition Terminal User Manual
74
to call the
on
to call