Set Wiegand Parameters
You can set the Wiegand transmission direction.
Steps
Note
Some device models do not support this function. Refer to the actual products when configuration.
1. Click Configuration → Access Control → Wiegand Settings .
2. Check Wiegand to enable the Wiegand function.
3. Set a transmission direction.
Input
The device can connect a Wiegand card reader.
Output
The can connect an external access controller. And the two devices will transmit the card No.
via Wiegand 26 or 34.
4. Click Save to save the settings.
Note
If you change the peripheral, and after you save the device parameters, the device will reboot
automatically.
Set Terminal Parameters
You can set terminal parameters for accessing.
Click Configuration → Access Control → Terminal Parameters .
You can set Working Mode as Access Control Mode. The access control mode is the device normal
mode. You should authenticate your credential for accessing.
Click Save to save the settings after the configuration.
9.6.10 Set Video Intercom Parameters
The device can be used as a door station, outer door station, or access control device. You should
set the device No. before usage.
Click Configuration → Intercom → Device No. .
If set the device type as Door Station or Access Control Device, you can set the floor No., door
station No., and click More to set Community No., Building No., and Unit No.
Click Save to save the settings after the configuration.
Face Recognition Terminal User Manual
95