Card Settings - HIKVISION Ultra Series User Manual

9.6.12 Card Settings

Set Card Security
Click Configuration → Card Settings → Card Type to enter the settings page.
Set the parameters and click Save.
Enable NFC Card
Enable the function and you can present the NFC card to authenticate. In order to prevent the
mobile phone from getting the data of the access control, you can disable NFC card to increase
the security level of the data.
Note
Disable NFC card cannot completely avoid presenting NFC card.
Enable M1 Card
Enable M1 card and authenticating by presenting M1 card is available.
M1 Card Encryption
Sector
M1 card encryption can improve the security level of authentication.
Enable the function and set the encryption sector. By default, Sector 13 is encrypted. It is
recommended to encrypt sector 13.
Enable CPU Card
Enable CPU card and authenticating by presenting CPU card is available.
Set Card No. Authentication Parameters
Set the card reading content when authenticate via card on the device.
Go to Configuration → Card Settings → Card No. Authentication Settings .
Select a card authentication mode and click Save.
Full Card No.
All card No. will be read.
Wiegand 26 (3 bytes)
The device will read card via Wiegand 26 protocol (read 3 bytes).
Wiegand 34 (4 bytes)
The device will read card via Wiegand 34 protocol (read 4 bytes).
Face Recognition Terminal User Manual
98