Time And Attendance Status Settings - HIKVISION Ultra Series User Manual

Parameter
Reader Auth. Mode (Card
Reader Authentication Mode)
Enable NFC Card
Enable M1 Card
Door Contact
Open Duration
Authentication Interval

7.9 Time and Attendance Status Settings

You can set the attendance mode as check in, check out, break out, break in, overtime in, and
overtime out according to your actual situation.
Note
The function should be used cooperatively with time and attendance function on the client
software.
Face Recognition Terminal User Manual
Note
Only the device with the fingerprint module supports the
●
fingerprint related function.
Biometric recognition products are not completely applicable
●
to anti-spoofing environments. If you require a higher
security level, use multiple authentication modes.
If you adopt multiple authentication modes, you should
●
authenticate other methods before authenticating face.
Select the card reader's authentication mode.
Enable the function and you can present the NFC card to
authenticate. In order to prevent the mobile phone from getting
the data of the access control, you can disable NFC card to
increase the security level of the data.
Note
Disable NFC card cannot completely avoid presenting NFC card.
Enable the function and you can present the M1 card to
authenticate.
You can select "Remain Open" or "Remian Closed" according to
your actual needs. By default, it is Remian Closed.
Set the door unlocking duration. If the door is not opened for
the set time, the door will be locked. Available door locked time
range: 1 to 255s.
Set the device authenticating interval. Available authentication
interval range: 0 to 65535.
Description
63