Activate Via Web Browser; Activate Via Sadp - HIKVISION Ultra Series User Manual

Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
Note
Characters containing admin and nimda are not supported to be set as activation password.
After activation, you should select language, set password change type, set application mode, set
network, set platform parameters, set privacy parameters, and set administrator.

5.2 Activate via Web Browser

You can activate the device via the web browser.
Steps
1. Enter the device default IP address (192.0.0.64) in the address bar of the web browser, and press
Enter.
Note
Make sure the device IP address and the computer's should be in the same IP segment.
2. Create a new password (admin password) and confirm the password.
Caution
STRONG PASSWORD RECOMMENDED-We highly recommend you create a strong password of
your own choosing (using a minimum of 8 characters, including upper case letters, lower case
letters, numbers, and special characters) in order to increase the security of your product. And
we recommend you reset your password regularly, especially in the high security system,
resetting the password monthly or weekly can better protect your product.
3. Click Activate.
4. Edit the device IP address. You can edit the IP address via the SADP tool, the device, and the
client software.

5.3 Activate via SADP

SADP is a tool to detect, activate and modify the IP address of the device over the LAN.
Before You Start
Get the SADP software from the supplied disk or the official website http://
●
www.hikvision.com/en/ , and install the SADP according to the prompts.
The device and the PC that runs the SADP tool should be within the same subnet.
●
The following steps show how to activate a device and modify its IP address. For batch activation
and IP addresses modification, refer to User Manual of SADP for details.
Face Recognition Terminal User Manual
19