Set Rs-485 Parameters - HIKVISION Ultra Series User Manual
Face recognition terminal
Hide thumbs
Also See for Ultra Series:
- User manual (39 pages) ,
- Quick start manual (34 pages) ,
- User manual (126 pages)
Table of Contents
Advertisement
Note
Only digits, letters, and special characters are allowed in the password.
5. Set the Wi-Fi's parameters.
- By default, DHCP is enable. The system will allocate the IP address, the subnet mask, and the
gateway automatically.
- If disable DHCP, you should enter the IP address, the subnet mask, and the gateway manually.
6. Tap OK to save the settings and go back to the Wi-Fi tab.
7. Tap
to save the network parameters.
7.2.3 Set RS-485 Parameters
The face recognition terminal can connect external access controller, secure door control unit or
card reader via the RS-485 terminal.
Steps
1. Tap Comm. (Communication Settings) on the Home page to enter the Communication Settings
page.
2. On the Communication Settings page, tap RS-485 to enter the RS-485 tab.
Face Recognition Terminal User Manual
41
Advertisement
Table of Contents
