The Hp 3324A As A Function Generator - HP 3324A Operating And Programming Manual

The HP 3324A as
a Function
Generator
Keystrokes
1 .
Note
4-2 Getting Started
In the non-compatible mode, at power-on the last setting
used is the new state. Any settings stored previous to
power-down will still be stored in the memory registers.
In the HP 3325A compatible mode, all stores are deleted
and the default state is set. The main signal output is
also enabled (LED to the right of the I-j switch
is lit).
The following is an example of how to set up the HP
3324A as a standard function generator. It shows how
to choose a waveform, set the frequency, amplitude and
offset of the output signal, and how to enable the signal.
The waveform menu is shown in the display.
Figure 4-1. The Waveform Display
If the sinewave is not blinking, move the cursor until it
I
does.
Result