Table of Contents
Advertisement
Setting up a
Multi-Interval
Sequence
SINGLE
INTERVRL
C O N T
Note
7-8 Sweep
This section will show how to set up a multi-interval
sweep sequence. Press lsweepl to show the Sweep menu.
To choose the multi-interval mode, put the cursor on
"INTERVAL" and press (Select). A display similar to that
in Figure 7-4 will be shown.
1
START-FREQ
7
S W E E P - T I E
Figure 7-4. The Multi-Interval Display
In the sweep display, two values in the form "nn of
xx" are shown (in the above example "nn" = "1" and
whose parameters you will see if you look at the start
frequency, stop frequency and so on. The "xx" means
the number of intervals that can be programmed and
used in the sweep sequences.
If the number of intervals available is not enough for
your needs, change the amount required now, because
when a change in the number of stores/intervals is made
all of the intervals are reset to the default value, and any
stores are cleared.
To change the number of stores/intervals, press (Util and
scroll the menu until "sto.: xx int.: xx" is shown. Move
the cursor under "int." and enter the value of intervals
required. Press [Enter) to confirm this. (To get back to
the Sweep menu, press a).)
Advertisement
Table of Contents
