Table of Contents
Advertisement
Modifying
a
Parameter
A parameter can be simultaneously updated using the
modify keys. This is done by activating the parameter
that you wish to change, and then pressing the yellow
"M" is shown in the display, to indicate that you are in
the modify mode. The cursor is automatically placed on
the most significant digit (to the far left). To move the
cursor to another digit use the It=) and (?J keys. There
are two ways to change a digit in the modify mode:
the numeric keypad. There is no need to press (Enter).
Use the a/@ keys to increase/decrease the digit
n
by 1. Holding the key in will increase/decrease the
value at a faster rate. Note that, except on the most
signicant digit, increasing from 9 to 10 causes the 1 to
be carried to the next digit position, and decreasing
from 0 to 9 will cause the preceeding
decreased by one. See the example.
To delete a digit place the cursor to the right of the digit
you wish to delete, and then press [BackSpace).
The modify mode is useful because the output is
changed immediately, and does not need to be realised
with a unit key. To leave the modify mode either press
the yellow (Modify) key again, or press one of the Menu or
Parameter keys.
digit to be
Parameters
5-3
Advertisement
Table of Contents
