Table of Contents
Advertisement
MESSAGE:
no swp in TTL/DC
Command:
Cause:
A TTL clock or DC waveform is the
current waveform. It is impossible to
sweep with these waveforms.
Change to one of the other waveforms.
Remedy:
MESSAGE:
offs. out range
Command:
The offset value entered is not valid.
Cause:
Enter an offset from 0 to 65 V for a DC
Remedy:
only signal. For a DC and AC signal see
the amplitude/offset table in chapter 5.
MESSAGE:
phase cal Wed
Command:
Cause:
The attempted phase calibration has
failed.
Check to make sure that the two HP
Remedy:
3324As are connected properly.
MESSAGE:
phase out range
Command:
(Phase)
Cause:
The phase value entered is not valid.
Enter a phase value between -720" and
Remedy:
Error Messages F-5
Advertisement
Table of Contents
