Table of Contents
Advertisement
Getting Started
Introduction
Powering Up
Caution
This chapter gives a very brief description of how to get
started with the HP 3324A. This includes how to power
up, an example of setting the parameters for a standard
function generator, and an example of setting up a
sweep.
Before connecting the HP 3324A to an AC power source
make sure that the instrument is set for the local line
voltage. This will avoid damage to the instrument.
See Appendix C Installation, if you don't know how to
do this.
To power on press the Stand-by switch on the front
panel. The HP 3324A will then perform a series of
self-tests. The initial state of the HP 332412 depends on
if the instrument is in the HP 3325A compatibility mode
or not. The mode can be set and seen in the IJtilities
menu (see Chapter 8).
Getting Started 4-1
Advertisement
Table of Contents
