Table of Contents
Advertisement
1 0 0
C-4 Installation
To change the line voltage and fuse:
1. Remove the power cord.
2. To check or replace the fuse, press the fuse holder in
slightly, using a screw driver, and turn it to release
the catch. Pull out the fuse holder.
3. To reinstall the fuse, insert a fuse with the proper
rating into the fuse holder, place it back into position,
and push in and turn, using a screw driver.
4. To change the line voltage, turn the instrument onto
its back, so that the voltage selector switches are
situated in the top right of the instrument.
5. Then using a screwdriver, move the switches into the
position required for the voltage to be used, as shown
in Figure C-l.
120
2 2 0
Figure C-l. Voltage Selection Possibilities
VOLTAGE
SELECTOR
2 4 0
Advertisement
Table of Contents
