Table of Contents
Advertisement
The Sweep Keys
Note
7-22
Sweep
This section explains the use of the sweep keys placed to
the right of the front panel.
Figure 7-12. The Sweep Keys
Once a sweep has been defined it can then be started.
This is done using the (ResetStartJ key. The (Start) key
performs three functions for the sweep operations:
(Reset) cancels the sweep. The signal then output
is the current waveform at the freauencv at which the
sweep was stopped. Pressing (-)-again will
cause the sweep to be reset to the start of the sweep.
A sweep can also be stopped by pressing the (Freql key.
The signal then output is the current waveform at the
frequency at which the sweep was stopped, that is when
For single sweeps, the first press of the (Reset) key
n
resets the sweep to the start of the sweep. Pressing the
key again will cause the sweep to begin.
key resets the sweep to the start of the sweep and
begins the sweep.
Advertisement
Table of Contents
