Product Key - Oki LP-1040 Maintenance Manual

1.6.2

Product Key

Since the firmware is used for both LP-2060 and LP-1040 models, a product key of 20 digits
(see below) must be set to the Printer to differentiate the printer models.
Example: 1206-2EEA-FDE6-2B83-1B57
The product key is a unique number different for each model and each serial number.
The product key is indicated at the following locations.
- The sticker at the rear side of the Printer.
- Under Printer Information in the Menu from the operation panel.
- The printout printed using Print System Settings.
- Printer Information screen of the Web function.
The product key is set by default to the Printer, but must be set again after the ARC or ASC
board has been replaced.
The product key can be set:
- on the error screen that appears when the product key is not correct,
- under Enter Product Key in Menu (1/2) -> Menu (2/2) of the operation panel.
* The EEPROM must always be replaced after replacing the ARC or ASC board.
See p. 9-55 for the ARC board EEPROM replacement procedure.
See p. 9-63 for the ASC board EEPROM replacement procedure.
When the product key is not correct, the symbol * is added at the end of the serial number
displayed
- under Printer Information in the Menu from the operation panel,
- on the printout printed using Print System Settings,
- on the Printer Information screen of the Web function.
Note also that when a highlighted sentence as shown below is displayed on the Ready screen,
you will be able to use the Printer only for the time displayed.
Chapter 1 Maintenance Work Process Overview
1-11