4.
Loosen the two screws holding down the
scanner glass on the left side of the scanner
cover.
Note
Do not remove the screws.
5.
Loosen the two screws holding down the
scanner glass on the right side of the scanner
cover.
Note
Do not remove the screws.
6.
Remove the clamp at the location shown in
the photo.
7.
Remove only one of the screws securing
STOPPER-PINCH-UNIT-R, then use the
other screw as a pivot point to slide the part
over as shown in the photo.
Chapter 9 Parts Disassembly, Assembly, and Replacement
9-179