Regular Service Inspection Work Items And Their Details; Table 3-1 Regular Service Inspection Items - Oki LP-1040 Maintenance Manual

3.1

Regular Service Inspection Work Items and Their Details

Regular service inspections should be carried out once every 12 months at a minimum.
However, in order to ensure the best printout image quality we recommend performing these
inspections once every 6 months.
The work involved in a regular service inspection is detailed in Table 3-1. Items related to the
scanner are detailed in Table 3-2.
TIP
No. Work Item Part Name
1 Thermistor THERMISTOR
(TH01,
TH02, TH04,
TH05)
2 Detach DETACH
needle NEEDLE
electrode
3 Suction belt BELT TRANS
4 Developer SPACER DEV
gap spacer
5 Gap spacer SPACER TRA
& transfer ROLLER TRA
roller 3565
6 Heat roller ROLLER
HEAT
◇ Always work with the power turned off, unless otherwise required.
◇ Always receive confirmation from the user before replacing any parts.

Table 3-1 Regular Service Inspection Items

Work Details
Wipe clean with a cleaning cloth.
Replace if it looks like the plate spring is
bent.
<Note>
Be careful not to bend the secured plate
spring.
<Note>
When cleaning, you can extend the
life of the parts by rotating the
positions of TH01, TH02, and TH04
(due to central sensor wear occurring
quickly).
Suck up all dirt using a toner vacuum
cleaner.
Use compressed air to blow away dirt.
<Note>
The electrode is easily bent, so be
careful when working around it.
Check to ensure the belt is properly
installed.
<Note>
Be careful not to break the belt's
PS06 arm when performing this
check.
If dirt is significant, wipe off with a dry
cloth while rotating the roller.
<Note>
Do not touch the roller (magnetic) with
your bare hands.
Use a Ciegal cotton wipe to wipe dry
the roller while rotating it.
<Note>
Do not hold the guide as it can easily
break off.
Use a Ciegal cotton wipe soaked in
HR Cleaner (30790-0125) to clean the
surface of the roller.
<Note>
Wipe off with a dry Ciegal cotton wipe
afterwards.
Chapter 3 Regular Service Inspectionse
Cumulative Cumulative Print
Print Length for Length for Part
Cleaning Replacement
Recommended Recommended *
5km 100km
(196850.39 (3937007.87
inches) inches)
5km 100km
(196850.39 (3937007.87
inches) inches)
5km 100km
(196850.39 (3937007.87
inches) inches)
5km 100km
(196850.39 (3937007.87
inches) inches)
5km 100km
(196850.39 (3937007.87
inches) inches)
5km 100km
(196850.39 (3937007.87
inches) inches)
Reference
Item
9.10.8
9.17.2
9.18.4
9.6.5
3.2.3
9.17.3
9.17.4
9.10.13
3-61