■ The heater temperature control system for printing
The Printer receives the RIP data.
(Temperature)
Printheater set temperature
Preheater set temperature
Afterheater set temperature
Standby set temperature
Ambient temperature
Display the heater control menu.
Press the
key to display the heater control menu.
H E A T E R
Key operation in the heater control menu
and
keys
and
keys
key
M E N U
key
key
C AN CEL
Finish displaying the heater control menu
Press the
key while the heater control menu is displayed.
H E A T E R
■ When the heater control menu display finishes automatically
H E A T E R D I S P L A Y E N D
If no key is input for 30 seconds while the heater control menu is displayed, a message "HEATER DISPLAY END"
appears automatically for two seconds and then the heater control menu display finishes. While this message is
displayed, no key input is effective.
80
IP-7900-20/21/7700-20/21 Advanced Operation Guide
Print
Set temperature maintained
- The heaters become standby at the temperature below.
Preheater: 45 ºC
Printheater: 45 ºC
Afterheater: 60 ºC
However, the temperature above is lowered to the setup temperarure if the
setup temperature is lower than the standby temperature above.
Select the heater whose temperature is to be set.
Set the heater temperature.
Turns the heater ON or OFF.
When this key is pressed for 1.5 seconds while the heater control menu
is displayed, all the heaters are forcibly turned on even without print
operation. (The heating control starts.)
Pressing this key for 1.5 seconds with the heater control menu displayed
cancels the heater-on state forcibly specified by the
control stops.)
Standby time
Standby temperature maintained
Temperature control stop
key. (The heating
(Time)