Oki LP-1040 Maintenance Manual page 85

(5) Remaining Paper Based
Executes a print operation for correcting the cut length based on the remaining paper.
<Preparation>
Prepare two rolls, one with the maximum remaining length and one with the minimum
remaining length, of the paper width and paper type you want to adjust.
* They are not necessary if the cut lengths from the roll front and the roll end are already known,
and only enter the cut length with the roll front in Length Roll Front, and the cut length with
the roll end in Length Roll End.
(1) Select the paper width and the paper type.
(2) Install the roll with the maximum remaining length in roll 1.
(3) Select the print length with which you often print on the roll you have set, and click the Start
Print button.
(4) Measure the cut length of the third printout, and enter the value in Length Roll Front.
(5) Install the roll with the minimum remaining length in roll 1.
(6) Enter the same value as (3) in Print Length, and click the Start Print button.
(7) Measure the cut length of the third printout, and enter the value in Length Roll End.
(8) Click the Auto Calcul RAM Value button to display the RAM value automatically.
* Repeat the procedure with a different paper width and paper type if required.
(9) Click the Save button to save the RAM Value in the EEPROM.
Note
2-36
◇ A confirmation window appears when you click the Save button.
When saving the new parameter, not only the value for the currently displayed
screen, but all RAM values that have been changed at this point are saved.