Preparing For Calibration - Oki LP-1040 Maintenance Manual

11.1.5

Preparing for Calibration

(1) Connecting the Printer
Configure the Printer's network connection and confirm that it is connected to the calibrating
PC.
(2) Launching the Tools
(a) Open the Printer's web-based scanner parameter calibration page
Instructions
(i) Launch the WEB browser on the calibrating PC, enter the IP address of the printer in the
URL (address) bar, and access the printer's Web tool.
(ii) When the main page for the printer's web tool appears in the browser, click Maintenance
in the list on the left side of the page. Then, click 8. Special Maintenance.
(iii) Enter the following login name and password.
Login name: maintenance
Password for maintenance: tktk2010
or
Login name: t2t2
Password for maintenance: 12325802
(iv) Click the Scanner Maintenance link on the maintenance page and open the Scanner
Parameter page.
* For easier operation, you are recommended to open this link in a new window.
Chapter 11 Scanner Calibration
11-7