Oki LP-1040 Maintenance Manual page 724

Annex A ARC1/ARC2 Board Configuration and
SW3
A.1 DIP Switch Settings
DIP switch settings on the ARC1/ARC2 circuit board are shown below. When the DIP switch
settings are changed, be sure to reset the power to the circuit board in order to apply those
changes.
A.1.1 ARC1/ARC2 Circuit Board's SW1 DIP Switch Setting
All bits of the DIP switch SW1 should be set to the Off side.
Off
On
4
Display
SW1
3 2 1
SW4 SW2 LED 9 to LED 2
Note
Risk of explosion if
battery is replaced by an
incorrect type.
Dispose of used batteries
according to the
instructions.
A-1