Oki LP-1040 Maintenance Manual page 592

3.
Look at the slope from one end and adjust the shape of the slope with your fingers until it
forms a smooth convex surface along all its length (shape of a bow).
- The slope must be symmetrical in the longitudinal direction.
- No protruding or hollowed areas must not be found.
OK
Not acceptable: Not a smooth
surface
Not acceptable: Forms an
angle
Note
If you notice irregularities at the supporter locations, loosen the supporter screws, adjust the
shape, and then secure the screws again.
If wrinkles still appear after performing the adjustment above, try the following solutions.
(1) Place the slope in a higher position.
- Align the central supporter to the median position between the fourth and the fifth
graduations from the bottom.
- Align the second supporters from the center to the fourth graduation from the bottom.
- Align the third supporters from the center to the median position between the second and
the third graduations from the bottom.
(2) Increase the heat roller speed.
Increase the speed in the range between the standard value and −50.
(Change by increments of 10, or 5 to fine adjust)
See Heat Roller Speed Adjustment Value on page 2-43 for the standard values.
10-60
Slope viewed from an end Adjust the shape with your fingers