To Connect The Probe - Rigol DS6062-DEMO User Manual

To Connect the Probe

RIGOL provides passive and active probes for the DS6000 series oscilloscopes. For
detailed technical information of the probes, please refer to corresponding Probe
User's Guide. The following are the probes recommended for use with this
oscilloscope.
Model
RP5600
RP3500
RP6150
RP7150
Connect the Probe:
1. Connect the BNC terminal of the probe to a channel BNC connector of the
oscilloscope at the front panel.
2. Connect the probe tip to the circuit point under test and connect the ground
alligator clip of the probe to the circuit ground terminal.
DS6000 User's Guide
Description
600 MHz, passive probe, standard, auto detection
500 MHz, passive probe, optional, auto detection
1.5 GHz, passive probe, DS610X standard, auto detection
1.5 GHz, active probe, optional, auto detection
Figure 1-7 To Connect the Probe
RIGOL
1-9