Basic Settings - Rigol DHO900 Series User Manual

-
TIP
• When the three IP configuration types are all turned on, the priority of the parameter
configuration from high to low is "DHCP", "Auto IP", and "Static IP".
• The three IP configuration types cannot be all turned off at the same time.
mDNS
Click or tap the mDNS on/off switch to enable or disable the multicast Domain Name
System (mDNS). This system is used to provide the function of DNS server for service
discovery in a small network without a DNS server.
Host Name
A maximum of 26-byte strings can be supported.
Apply the Network Parameter Setting
Drag the menu up on the screen. Click or tap Apply at the bottom to validate the
current network parameter setting.
24.2

Basic Settings

In the Utility menu, click or tap Setup to enter the basic setting menu.
Language
This product supports menus in multiple languages, including the display of the help
information, prompt messages, and interface. Click or tap the drop-down button of
Language to select the specified system language.
Load Last
You can set the system configuration to be recalled when the oscilloscope is powered
on again after power-off. Click or tap "Default" or "Last" for Load last.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
You are recommended to ask your network administrator for a gateway
address available.
This setting will be saved in the non-volatile memory; if "Load Last" is set to
"Last", then DHCP and Auto IP are disabled at the next power-on. The
instrument will load the preset gateway automatically
Set the DNS address
You can set this parameter in Static IP mode. The format of the DNS address
is "nnn.nnn.nnn.nnn". The range for the first segment (nnn) of the address is
from 0 to 223 (except 127); and the range for the other three segments is
from 0 to 255. You are recommended to ask your network administrator for
an address available.
Generally, you do not need to set the DNS, so this parameter setting can be
ignored.
System Utility Function Setting
DHO900 User Guide
249