Protocol Decoding
In RS232, baud rate is used to represent the transmission rate (namely bits per
second) of the data. You need to set the start bit, data bits, check bit (optional), and
stop bits for each frame of data.
•
Start Bit: indicates when to output data.
•
Data Bit: indicates the number of data bits actually contained in each frame of
data.
•
Check Bit: used to check whether the data are properly transmitted.
•
Stop Bit: indicates when to stop outputting data.
In the Decode menu, click or tap the drop-down button of Bus Type to select RS232,
then configure the parameters for RS232 decoding.
Bus Status
Click or tap the Bus Status on/off switch to enable or disable the bus decoding.
Quickly Apply Trigger Settings to Decoding
Copy trig indicates applying the trigger settings to the specified decoding setting.
Click or tap Copy Trig to apply the trigger settings to the specified decoding setting.
DHO900 User Guide
200
Figure 18.5 RS232 Decoding Menu
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.