Figure 11.1 Dvm Setting Menu - Rigol DHO900 Series User Manual

Select the Measurement Source
Click or tap the Source drop-down button to select the desired source. The analog
channel (CH1-CH4) can be selected to be the measurement source.
Even if the analog channel (CH1-CH4) is not enabled, you can still perform the DVM
measurements.
Select the Measurement Mode
In the Mode item, you can select the DVM mode. The DVM measurement modes
include AC RMS, DC, and AC+DC RMS.
• AC RMS: displays the root-mean-square value of the acquired data, with the DC
component removed.
• DC: displays the average value of the acquired data.
• AC+DC RMS: displays the root-mean-square value of the acquired data.
Set the Limits
Click or tap the Beeper on/off switch to turn on or off the beeper. When the beeper is
turned on, you can enable the beeper to sound an alarm when the voltage value is
inside or outside the limited range.
• Limits Condition Setting
Click or tap the When toggle button to select "In Limits" or "Out Limits".
-
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.

Figure 11.1 DVM Setting Menu

In Limits: when the voltage value is inside the limited range, you can enable
or disable the beeper to sound an alarm.
Digital Voltmeter (DVM) and Frequency Counter
DHO900 User Guide
157