Function Inspection For The Passive Probe - Rigol DS4000E Series Quick Manual

RIGOL
To Connect the Tektronix Probe
English
1. Connect the Tektronix probe to one end of T2R1000 adapter properly.
2. Connect the other end of T2R1000 adapter to the analog channel input
terminal or the external trigger input connector on the front panel of the
oscilloscope.
3. Connect the ground terminal of the probe to the circuit ground terminal,
and connect the probe tip to the test point of the circuit.
For the specified model of the Tektronix probe, after connecting the probe, you
can perform probe calibration and offset voltage adjustment if necessary. For
detailed procedures, refer to the User's Guide of this instrument.

Function Inspection for the Passive Probe

You need to perform probe function inspection according to the steps below
before making measurements with the passive probe.
1. Press Default  OK to restore the oscilloscope to factory settings.
2. Connect the ground alligator clip of the probe to the "Ground Terminal" as
shown in Figure 7 below.
3. Connect one end of the probe to CH1 input terminal of the oscilloscope,
and connect the other end to the "Probe Compensation Signal Output
Terminal" as shown in Figure 7.
14
T2R1000
Tektronix Probe
DS4000E Quick Guide