Select The Measurement Item; Figure 10.4 Vertical Measurement Items - Rigol DHO900 Series User Manual

reference is negative. The area measured is the algebraic sum of the whole
period area.
10.2.2

Select the Measurement Item

In the Measure menu, click or tap Horizontal, Vertical, or Other to go to the desired
menu. You can also slide to select the measurement item to enter the corresponding
interface, as shown in
the measurement items to enable the measurements. This series allows you to enable
measurements of up to 14 items at the same time.
TIP
You can also refer to
• Vertical: Vmax, Vmin, Vpp, Vtop, Vbase, Vamp, Vupper, Vmid, Vlower, Vavg,
VRMS, Per. VRMS, Overshoot, Preshoot, Area, Per.Area, and AC.RMS.
• Horizontal: Period, Frequency, Rise Time, Fall Time, +Width, -Width, +Duty, -
Duty, Positive Pulse Count, Negative Pulse Count, Rising Edge Count, Falling
Edge Count, Tvmax, Tvmin, +Slew Rate, and -Slew Rate.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Figure 10.4 Figure 10.5
,
Multi-pane Windowing
to enable all measurements.

Figure 10.4 Vertical Measurement Items

Figure 10.6
, and . Click or tap any of
DHO900 User Guide
Measurements
141