Checking The Oil Cooler; Installing The Oil Cooler - Yamaha XSR 900 2022 Service Manual

EAS30441

CHECKING THE OIL COOLER

1. Check:
• Oil cooler
Cracks/damage → Replace.
2. Check:
• Oil cooler inlet hose
• Oil cooler outlet hose
Cracks/damage/wear → Replace.
EAS30442

INSTALLING THE OIL COOLER

1. Clean:
• Mating surfaces of the oil cooler and the
crankcase
(with a cloth dampened with lacquer thinner)
2. Install:
• O-ring
New
• Oil cooler
• Oil cooler bolt "1"
Oil cooler bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
LOCTITE®
TIP
• Before installing the oil cooler, apply lithium-
soap-based grease to the O-ring.
• Make sure the O-ring is positioned properly.
3. Fill:
• Cooling system
(with the specified amount of the recom-
mended coolant)
Refer to "CHANGING THE COOLANT" on
page 3-28.
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Refer to "CHANGING THE ENGINE OIL" on
page 3-25.
1
4. Check:
• Cooling system
Leaks → Repair or replace any faulty part.
Refer to "INSTALLING THE RADIATOR" on
page 6-5.
5. Measure:
• Radiator cap valve opening pressure
Below the specified pressure → Replace the
radiator cap.
Refer to "CHECKING THE RADIATOR" on
page 6-5.
6-8
OIL COOLER