Checking The Rear Wheel Drive Hub; Installing The Drive Chain - Yamaha XSR 900 2022 Service Manual

EAS30233

CHECKING THE REAR WHEEL DRIVE HUB

Refer to "CHECKING THE REAR WHEEL
DRIVE HUB" on page 4-22.
EAS30234

INSTALLING THE DRIVE CHAIN

1. Install:
• Drive chain
ECA17410
NOTICE
Be sure to put on safety goggles when work-
ing.
TIP
Install the drive chain joint with the drive chain
cut & rivet tool.
Drive chain cut & rivet tool
90890-01550
Drive chain cut & rivet tool
YM-01550
a. When press fitting the connecting plate "1",
make sure the space "a" between the end
of the connecting pin "2" and the connecting
plate is 1.2–1.4 mm (0.05–0.06 in).
b. After riveting, make sure the diameter be-
tween the edges "b" of the connecting pin
"2" is 5.7–6.0 mm (0.22–0.24 in).
c. After riveting, make sure the space "c",
which is inside of the connecting link "3" and
inside of the connecting plate "1", is 14.35–
14.55 mm (0.565–0.573 in).
2. Lubricate:
• Drive chain
Recommended lubricant
Chain lubricant suitable for O-
ring chains
3. Install:
• Drive sprocket
• Washer "1"
• Drive sprocket nut "2"
Drive sprocket nut
160 N·m (16 kgf·m, 118 lb·ft)
LOCTITE®
TIP
• Thoroughly clean all the drive sprocket nut
seat and threads of drive axle.
• While applying the rear brake, tighten the drive
sprocket nut.
• Install washer "1" with the "OUT" mark "a" fac-
ing out.
• Stake the drive sprocket nut "2" at cutouts "b" in
the drive axle securely.
4-91
CHAIN DRIVE
New
2
1
b
a