Yamaha XSR 900 2022 Service Manual page 53

1. Wire harness (to gear position sensor)
2. Starter motor lead
3. Gear position sensor coupler
4. Gear position sensor
5. Shift sensor
6. Sidestand switch
7. Sidestand switch lead
8. Fuel tank drain hose
9. Stator coil assembly lead
10. Shift sensor lead
11. Canister breather hose
12. Canister purge hose (purge cut valve sole-
noid to canister)
13. Holder
14. Shift rod joint
15. Shift arm
16. Shift rod joint and dust cover
17. Clamp
A. To fuel pump
B. Route the wire harness (to gear position sen-
sor) on the left side of the starter motor lead.
C. Face the paint mark on the fuel tank drain
hose outward. Align the holder with the paint
mark on the fuel tank drain hose.
D. Route the shift sensor lead to the front of the
shift sensor.
E. Point the open ends of the clamp to the right.
F. Left side of the vehicle
G. Forward of the vehicle
H. Arrange the sidestand switch lead, canister
breather hose and fuel tank drain hose from
inside of the vehicle in order.
I. Pass the shift sensor lead in front of the shift
rod joint and shift arm.
J. Bend the shift sensor lead upward at the bot-
tom of the sensor side.
K. Fix the shift sensor and its lead to the top part
of the locknut on the shift sensor with the
clamp.
2-24
CABLE ROUTING