Measuring The Engine Oil Pressure - Yamaha XSR 900 2022 Service Manual

7. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Engine oil quantity
Quantity (disassembled)
3.50 L (3.70 US qt, 3.08 Imp.qt)
Oil change
2.80 L (2.96 US qt, 2.46 Imp.qt)
With oil filter removal
3.20 L (3.38 US qt, 2.82 Imp.qt)
8. Install:
• Engine oil filler cap
(along with the O-ring
9. Start the engine, warm it up for several min-
utes, and then turn it off.
10.Check:
• Engine
(for engine oil leaks)
11.Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL" on page 3-24.
EAS30810

MEASURING THE ENGINE OIL PRESSURE

1. Check:
• Engine oil level
Below the minimum level mark "a" → Add the
recommended engine oil to the proper level.
2. Start the engine, warm it up for several min-
utes, and then turn it off.
ECA13410
NOTICE
When the engine is cold, the engine oil will
have a higher viscosity, causing the engine
oil pressure to increase. Therefore, be sure
to measure the engine oil pressure after
warming up the engine.
)
New
a
PERIODIC MAINTENANCE
3. Remove:
• Oil pressure switch joint bolt "1"
• Oil pressure switch joint (with the oil pressure
switch) "2"
EWA12980
WARNING
The engine, muffler and engine oil are ex-
tremely hot.
2
4. Install:
• Oil pressure gauge joint 18 mm "1"
• Oil pressure switch joint bolt "2"
Oil pressure gauge joint 18 mm
90890-04176
YU-04176
Oil pressure switch joint bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
5. Install:
• Oil pressure gauge "1"
• Adapter C "2"
Oil pressure gauge set
90890-03120
3-26
1
1
2