Yamaha XSR 900 2022 Service Manual page 61

1. ABS ECU (Electronic Control Unit)
2. Battery box
3. Fuse box
4. Brake light relay
5. Tail/brake light coupler
6. Rear turn signal light coupler (right)
7. License plate light coupler
8. Rear turn signal light coupler (left)
9. License plate light lead
10. Rear turn signal light lead (left)
11. Rear turn signal light lead (right)
12. Tail/brake light lead
13. Joint coupler
14. YDT coupler
15. Starter relay coupler
16. Starter relay
17. Starter motor lead
18. Negative battery lead
19. Positive battery lead
20. Battery
21. Radiator fan motor relay
22. Positive battery lead (to starter relay)
23. Positive battery lead (to fuse box)
24. Wire harness (to YDT coupler)
25. Lower fender cover
A. Insert the fuse box to the ribs on the battery
box.
B. Insert the clamp into the hole of the battery
box.
C. Insert the tail/brake light coupler into the hole
of the battery box.
D. Insert the rear turn signal light coupler (right)
into the hole of the battery box.
E. Insert the rear turn signal light coupler (left)
into the hole of the battery box.
F. Pass the license plate light lead from the front
side of the vehicle, and arrange it under the
wire harness (to rear turn signal light), wire
harness (to tail/brake light lead) and wire har-
ness (to YDT).
G. Align with the white tape of the license plate
light lead and route the license plate light
lead through the guide of the battery box.
H. Align with the black tape of the tail/brake light
lead and route the tail/brake light lead
through the guide of the battery box. Pass the
license plate light lead to the rearward of the
vehicle on the rib of the battery box.
I. Pass the license plate light lead to the left
side of the rib of battery box.
J. Place the loose part of the wiring to the front
side of the vehicle.
K. Insert the YDT coupler until it stops the rib
stopper on the battery box.
L. Insert the radiator fan motor relay until it
stops the rib stopper on the battery box.
M. Pass the starter motor lead under the positive
battery lead (to starter relay).
N. Bend the positive battery lead as shown in
the illustration and fit it between the fuse box
and the battery.
O. Push the starter motor lead into the ribs of
the battery box.
P. Pass the joint coupler and wire harness (to
YDT coupler) through the guide of the battery
box.
Q. Pass the rear turn signal light lead (left), rear
turn signal light lead (right) and tail/brake light
lead through the guide of the battery box.
R. Insert the brake light relay until it stops the rib
stopper on the battery box.
2-32
CABLE ROUTING