Oil Cooler; Checking The Oil Cooler; Installing The Oil Cooler - Yamaha VMAX 2009 Service Manual

EAS26420

CHECKING THE OIL COOLER

1. Check:

• Oil cooler

Cracks/damage → Replace.
2. Check:
• Oil cooler inlet hose
• Oil cooler outlet hose
• Oil cooler adapter
Cracks/damage/wear → Replace.
EAS26430

INSTALLING THE OIL COOLER

1. Clean:
• Mating surfaces of the oil cooler and the oil
cooler adapter
(with a cloth dampened with lacquer thinner)
2. Install:
• O-ring New
• Oil cooler adapter
TIP
To hold the O-ring in place during installation,
apply Three bond 1541® to six points shown in
the illustration.
3. Install:
• O-ring New
• Oil cooler
• Oil cooler union bolt
Oil cooler union bolt
63 Nm (6.3 m·kgf, 45 ft·lbf)
TIP
• Before installing the oil cooler, lubricate the oil
cooler union bolt with a thin coat of engine oil.
• Make sure the O-ring is positioned properly.
4. Install:
• Oil cooler hoses
Refer to "COOLING SYSTEM DIAGRAMS"
on page 2-43.
5. Install:
• Oil filter cartridge
Refer to "CHANGING THE ENGINE OIL" on
page 3-11.
Oil filter cartridge
17 Nm (1.7 m·kgf, 12 ft·lbf)
6. Fill:
• Cooling system
(with the specified amount of the recom-
mended coolant)
Refer to "CHANGING THE COOLANT" on
page 3-20.
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Refer to "CHANGING THE ENGINE OIL" on
page 3-11.
7. Check:
• Cooling system
Leaks → Repair or replace any faulty part.
8. Measure:
• Radiator cap opening pressure
Below the specified pressure → Replace the
radiator cap.
Refer to "CHECKING THE RADIATORS" on
page 6-4.
6-6
OIL COOLER