Yamaha XSR 900 2022 Service Manual page 51

1. Radiator outlet hose
2. O sensor lead
2
3. Radiator cover (left)
4. Front turn signal light coupler (left)
5. O sensor coupler
2
6. Front turn signal light lead (left)
7. Front side panel (left)
8. Clutch cable
9. Handlebar switch lead (left)
10. Damper
11. Wire harness (to O
12. Wire harness (to front turn signal light (left))
13. ECU (Engine Control Unit)
14. ECU coupler 1
15. Wire harness
16. ECU coupler 3
17. ECU coupler 2
18. Handlebar switch coupler (left)
19. Radiator fan motor coupler
20. Wire harness (to oil pressure switch)
21. Radiator fan motor lead
22. Front wheel sensor coupler
23. Coupler cover
24. Coupler protector
25. Wire harness (to intake air temperature sen-
sor)
26. Main switch lead
27. Main switch coupler
28. Immobilizer unit coupler
A. Route the front turn signal light lead (left) and
wire harness (to O
2
the hole in the front side panel (left).
B. Face the buckle of the plastic locking tie
inward. Face the end of the plastic locking tie
downward and cut off the excess.
C. Left outside of the vehicle
D. Lower side of the vehicle
E. Route the O sensor lead to the inside of the
2
radiator outlet hose.
F. Place the O sensor lead inside the vehicle
2
on the damper.
G. Insert the O sensor coupler into the groove
2
of front side panel (left).
H. Insert the projection on the front turn signal
light coupler (left) into the hole in the front
side panel (left).
I. Route the leads through the guide in the front
side panel (left).
J. Pass the wire harness through the guide of
the air filter assembly.
K. Insert the camp of the wire harness (to radia-
tor fan motor) into the hole of coupler cover.
L. Insert the camp of the radiator fan motor cou-
pler into the hole of coupler cover.
M. Route the wire harness (to oil pressure
switch) between the brake hoses and frame.
sensor)
2
sensor coupler) through
N. Route the handlebar switch lead (left) on the
rear side of the wire harness. (to intake air
temperature sensor)
O. Insert the projection on the handlebar switch
coupler (left) into the hole of coupler cover.
P. Insert the immobilizer unit coupler into the rib
of coupler cover.
Q. Wrap the main switch coupler with a coupler
protector.
R. Face the hook of the coupler inward.
2-22
CABLE ROUTING