Changing The Engine Oil - Yamaha XSR 900 2022 Service Manual

ECA13361
NOTICE
• Engine oil also lubricates the clutch and the
wrong oil types or additives could cause
clutch slippage. Therefore, do not add any
chemical additives or use engine oils with a
grade of "CD" or higher and do not use oils
labeled "ENERGY CONSERVING II".
• Do not allow foreign materials to enter the
crankcase.
TIP
Before checking the engine oil level, wait a few
minutes until the oil has settled.
4. Start the engine, warm it up for several min-
utes, and then turn it off.
5. Check the engine oil level again.
TIP
Before checking the engine oil level, wait a few
minutes until the oil has settled.
EAS30657

CHANGING THE ENGINE OIL

1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
• Engine oil filler cap "1"
• Engine oil drain bolt "2"
• Gasket "3"
1
2 3
PERIODIC MAINTENANCE
4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil filter cartridge is also to be replaced,
perform the following procedure.
a. Remove the oil filter cartridge "1" with an oil
filter wrench "2".
Oil filter wrench
90890-01426
Oil filter wrench
YU-38411
b. Lubricate the O-ring of the new oil filter car-
tridge with a thin coat of engine oil.
ECA25890
NOTICE
Make sure the O-ring is positioned correctly
in the groove of the oil filter cartridge.
c. Tighten the new oil filter cartridge to specifi-
cation with an oil filter wrench.
Oil filter cartridge
17 N·m (1.7 kgf·m, 13 lb·ft)
6. Install:
• Engine oil drain bolt
(along with the gasket
Engine oil drain bolt
43 N·m (4.3 kgf·m, 32 lb·ft)
3-25
2 1
)
New