Yamaha XSR 900 2022 Service Manual page 561

A
1
Gy B
Is resistance ∞ Ω?
YES
→ Go to step 4.
NO
a. Replace the wire harness.
b. Crank the engine, and then check the DTC using the malfunction mode of the YDT.
Is it in the "Recovered" condition?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 4.
4. Installed condition of crankshaft position sensor.
• Check for looseness or pinching.
Refer to "GENERATOR AND STARTER CLUTCH" on page 5-37.
• Check the gap (0.85 mm (0.03 in)) between the crankshaft position sensor and the generator rotor.
Is check result OK?
YES
→ Go to step 5.
NO
a. Reinstall or replace the sensor.
b. Crank the engine, and then check the DTC using the malfunction mode of the YDT.
Is it in the "Recovered" condition?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 5.
5. Defective crankshaft position sensor.
• Check the crankshaft position sensor.
Refer to "CHECKING THE CRANKSHAFT POSITION SENSOR" on page 8-45.
B
1
Gy B
2
L/W W L/W W B B L/B L/B Y/B Y/B
B B/L B B B B B B/L L/R L/R L/R L/R
3
9-155
L/B Y/L O/W Lg/L P/W P V L L
L/W B/Y Br/L G/L Gy/G Br/W B/L B/L
L/Y L/W Lg/B G/W G/W
P0335
Gy
W/G W/Y