Yamaha XSR 900 2022 Service Manual page 55

1. Wire harness
2. Wire harness (to purge cut valve solenoid)
3. Fuel tank drain hose
4. Shift sensor lead
5. Canister breather hose
6. Sidestand switch lead
7. Plastic locking tie
8. Stator coil lead
9. Clutch cable
10. Cylinder head
11. Engine bracket
12. Frame
13. Purge cut valve solenoid coupler
14. Purge cut valve solenoid
15. Canister purge hose (purge cut valve sole-
noid to canister)
16. Bracket
A. Route the wire harness (to purge cut valve
solenoid) on the rear side of the stator coil
lead, sidestand switch lead and shift sensor
lead.
B. Route the fuel tank drain hose to the rear
side of the stator coil lead, sidestand switch
lead and shift sensor lead. Route the fuel
tank drain hose to the left side of the canister
purge hose (purge cut valve solenoid to can-
ister).
C. Route the shift sensor lead to the outside of
the fuel tank drain hose and canister breather
hose.
D. Left side of the vehicle
E. Route the stator coil lead to the front of the
vehicle and fix the gray tape part with a plas-
tic locking tie.
F. Fix the plastic locking tie is located 20–30
mm (0.79–1.18 in) away from the plastic lock-
ing tie "7". Face the locking part of the plastic
locking tie forward. Face the end of the plastic
locking tie rightward and do not cut off the
excess.
G. Right side of the vehicle
H. Forward of the vehicle
I. Route the clutch cable between the cylinder
head and the bracket.
J. Route the stator coil lead, shift sensor lead
and sidestand switch lead on the left side of
the clutch cable and canister purge hose
(purge cut valve solenoid to canister).
K. Insert the plastic locking tie into the hole of
the bracket.
L. Face the end of the plastic locking tie leftward
and cut off the excess.
M. Gray tape of shift sensor lead and side stand
switch lead. The plastic locking tie position is
aligned with the end of the gray tape (shift
sensor side and sidestand switch side).
2-26
CABLE ROUTING