Table of Contents
Advertisement
Introduction
Section 2
Congratulations on your purchase of a Thermo Scientific Nanopure Life
Science (UV/UF) ultrapure water system. This water purification system is
designed to provide nuclease-free (RNase and DNase), pyrogen-free, low
TOC, high resistivity, reagent grade water that exceeds ASTM Type I, ISO
3696 and CLSI-CLRW Type I standards. It uses a four-stage deionization
process combined with a UV lamp, an ultrafilter and a 0.2 micron filter to
polish suitable feed water (distilled, deionized, or reverse osmosis) to
produce pyrogen-free (<0.001 Eu/ml), low TOC (<5 ppb) water with a
resistivity of up to 18.2 megohm-cm. Water resistivity is continuously
monitored by a resistivity cell and displayed on a digital display.
The Nanopure is designed to automatically clean the ultrafilter by flushing
water through the filter for one minute every 12 hours. The water is sent
to drain.
The electronics can be verified and calibrated utilizing a N.I.S.T. Traceable
Calibration module. See Accessory Ordering information.
Please read the instructions carefully to ensure that you receive maximum
benefit from the Nanopure. Also, fill out and return the enclosed warranty
registration card as it will help us assure you of proper warranty coverage.
General Usage
Do not use this product for anything other than its intended usage.
Thermo Scientific
Nanopure Life Science (UV/UF)
2-1
Advertisement
Table of Contents
