Table of Contents
Advertisement
Section 5
installation
Install Control Panel
in Remote Loc. (cont.)
5-6
Nanopure Life Science (UV/UF)
For your convenience, the control panel can be removed from the unit and
mounted at a convenient location within 10 ft. (3.1 m.) of the unit. To
remove the control panel from the unit, follow the steps below.
1. Turn the unit OFF and disconnect it from the power supply.
2. Slide the control panel upward about 1/4" (.64 cm) to 3/8" (.95 cm) -
(just enough to clear connector on top cover), pull forward, and
remove. (The control panel fits tightly in the unit so it may be difficult
to remove.)
3. Replace the control panel with the blank panel provided with the unit
to protect the electrical connector.
4. Using the wall bracket as a template, locate and drill the mounting
holes in the wall. A minimum of two (customer-supplied) fasteners will
be required. Attach the wall bracket to the wall using the customer-
supplied fasteners.
5. Locate the 25-pin connector on the back top right of the unit. Remove
the protective black cover and store it for future use if the control panel
is returned to the top cover.
6. Locate the 10 ft. (3.1 m.) 25 pin M-F cable included with the unit;
attach the female end to the 25 pin connector on the back top right of
the unit, and the other end to the connector on the bottom of the
control panel.
7. Tighten the cable screws on each end to secure the cable to the unit
and control panel.
8. The control panel may now be mounted on the wall.
Thermo Scientific
Advertisement
Table of Contents
