Using The Cli; Global Config - TP-Link T1600G-52TS User Manual

Configuring LLDP
Included TLVs
4) Click Apply.
2.2

Using the CLI

2.2.1 Global Config

Enable the LLDP feature on the switch and configure the LLDP parameters.
Step 1
Step 2
Configure the TLVs included in the outgoing LLDP packets.
The switch supports the following TLVs:
PD: Used to advertise the port description defined by the IEEE 802 LAN station.
SC: Used to advertise the supported functions and whether or not these functions
are enabled.
SD: Used to advertise the system's description including the full name and version
identification of the system's hardware type, software operating system, and
networking software.
SN: Used to advertise the system name.
SA: Used to advertise the local device's management address to make it possible
to be managed by SNMP.
PV: Used to advertise the 802.1Q VLAN ID of the port.
VP: Used to advertise the protocol VLAN ID of the port.
VA: Used to advertise the name of the VLAN which the port is in.
LA: Used to advertise whether the link is capable of being aggregated, whether
the link is currently in an aggregation, and the port ID when it is in an aggregation.
PS: Used to advertise the port's attributes including the duplex and bit-rate
capability of the sending IEEE 802.3 LAN node that is connected to the physical
medium, the current duplex and bit-rate settings of the sending IEEE 802.3 LAN
node and whether these settings are the result of auto-negotiation during link
initiation or of manual set override action.
FS: Used to advertise the maximum frame size capability of the implemented MAC
and PHY.
PW: Used to advertise the port's PoE (Power over Ethernet) support capabilities.
configure
Enter global configuration mode.
lldp
Enable the LLDP feature on the switch.
LLDP Configurations
User Guide 361