Binding The Profile To Ports - TP-Link T1600G-52TS User Manual

Configuring Layer 2 Multicast

5.2.2 Binding the Profile to Ports

You can bind the created IGMP profile or MLD profile to ports, and configure the number of
multicast groups a port can join and the overflow action.
Binding the IGMP Profile to Ports
Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list |
port-channel port-channel-id | range port-channel port-channel-list }
Enter interface configuration mode.
Step 3 ip igmp filter profile-id
Bind the IGMP profile to the specified ports.
profile-id
Step 4 ip igmp snooping max-groups maxgroup
Configure the maximum number of multicast groups the port can join.
maxgroup
to 1000.
Step 5 ip igmp snooping max-groups action {drop | replace}
Specify the action towards the new multicast group when the number of multicast groups the
port joined exceeds the limit.
drop: Drop all subsequent membership report messages, and the port join no more new
multicast groups.
replace: Replace the existing multicast group owning the lowest multicast MAC address with
the new multicast group.
Step 6 show ip igmp profile [ id ]
Show the detailed IGMP profile configurations.
show ip igmp snooping interface [fastEthernet [ port-list ] | gigabitEthernet [ port-list ] | ten-
gigabitEthernet [ port-list ] | port-channel [ port-channel-list ] ] max-groups
Show the multicast group limitation on the specified port(s) or of all the ports.
Step 7 end
Return to privileged EXEC mode.
Step 8 copy running-config startup-config
Save the settings in the configuration file.
: Specify the ID of the profile to be bound. It should be an existing profile.
: Specify the maximum number of multicast groups the port can join. The range is 0
Multicast Filtering Configuration
User Guide 258