Using The Cli; Configuring 802.1Q Vlans; Configuring Mvr Globally - TP-Link T1600G-52TS User Manual

Configuring Layer 2 Multicast
Follow these steps to statically add ports to an MVR group:
1) Select the ports to add them to the MVR group.
2) Click Save.
4.2

Using the CLI

4.2.1 Configuring 802.1Q VLANs

Before configuring MVR, create an 802.1Q VLAN as the multicast VLAN. Add the all source
ports to the multicast VLAN as tagged ports. Configure 802.1Q VLANs for the receiver
ports according to network requirements. Note that receiver ports can only belong to one
VLAN and cannot be added to the multicast VLAN. For details, refer to
VLAN.

4.2.2 Configuring MVR Globally

Follow these steps to configure MVR globally:
Step 1 configure
Enter global configuration mode.
Step 2 mvr
Enable MVR Globally.
Step 3 mvr mode { compatible | dynamic }
Configure the MVR mode as compatible or dynamic.
compatible:
hosts to the IGMP querier. So the IGMP querier cannot learn the multicast groups membership
information from the switch. You have to statically configure the IGMP querier to transmit all
the required multicast streams to the switch via the multicast VLAN.
dynamic:
will forward them to the IGMP querier via the multicast VLAN (with appropriate translation of
the VLAN ID). So the IGMP querier can learn the multicast groups membership information
through the report and leave messages, and transmit the multicast streams to the switch via
the multicast VLAN according to the multicast forwarding table.
Step 4 mvr vlan vlan-id
Specify the multicast VLAN.
vlan-id:
Step 5 mvr querytime time
Specify the maximum time to wait for IGMP report on a receiver port before removing the port
from multicast group membership.
time:
and the default value is 5 tenths of a second.
In this mode, the switch does not forward report or leave messages from the
In this mode, after receiving report or leave messages from the hosts, the switch
Specify the ID of the multicast VLAN. Valid values are from 1 to 4094.
Specify the maximum response time. Valid values are from 1 to100 tenths of a second,
MVR Configuration
Configuring 802.1Q
User Guide 247