Upgrading The Firmware; Rebooting The Switch - TP-Link T1600G-52TS User Manual

Managing System
Start to backup user config file...
Backup user config file OK.

4.2.4 Upgrading the Firmware

Follow these steps to upgrade the firmware:
Step 1 enable
Enter privileged mode.
Step 2 firmware upgrade tftp ip-address ip-addr filename name
Upgrade the switch's backup image via TFTP server. To boot up with the new firmware, you
need to choose to reboot the switch with the backup image.
ip-addr
supported.
name
Step 3 Enter Y to continue and then enter Y to reboot the switch with the backup image.
The following example shows how to upgrade the firmware using the configuration file
named file3.bin. The TFTP server is 190.168.0.100.
Switch>enable
Switch#firmware upgrade ip-address 192.168.0.100 filename file3.bin
It will only upgrade the backup image. Continue? (Y/N):Y
Operation OK!
Reboot with the backup image? (Y/N): Y

4.2.5 Rebooting the Switch

Manually Rebooting the Switch
Follow these steps to reboot the switch:
Step 1 enable
Enter privileged mode.
Step 2 reboot
Reboot the switch.
Configuring Reboot Schedule
Follow these steps to configure the reboot schedule:
: Specify the IP address of the TFTP server. Both IPv4 and IPv6 addresses are
: Specify the name of the desired firmware file.
System Tools Configurations
User Guide 50