Configuring The Dhcp Relay Switch - TP-Link T1600G-52TS User Manual

Configuring DHCP Service
2) Configuring the DHCP Server
The detailed configurations on the DHCP server may be different among different
devices. You can refer to the related document that is for the DHCP server you use.
Demonstrated with a Linux ISC DHCP Server,
provides information about how to set its DHCP configuration file.

5.5.3 Configuring the DHCP Relay Switch

Using the GUI
1) Choose the menu L3 FEATURES > DHCP Service > DHCP L2 Relay > Global Config to
load the following page. In the Global Config section, enable DHCP L2 Relay globally
and click Apply. Enable DHCP L2 Relay on VLAN 1 and click Apply.
Figure 5-33 Enabling DHCP L2 Relay
2) Choose the menu L3 FEATURES > DHCP Service > DHCP L2 Relay > Port Config
to load the following page. Select port 1/0/1, enable Option 82 Support and select
Option 82 Policy as Replace. You can configure other parameters according to your
needs. In this example, keep Format as Normal and Remote ID Customization as
Disabled. Enable Circuit ID Customization and specify the Circuit ID as Group1. Click
Apply.
Configuration Examples
5.5.4 Configuring the DHCP Server
User Guide 492