Network Topology; Using The Gui - TP-Link T1600G-52TS User Manual

Configuring 802.1Q VLAN
3.3

Network Topology

The figure below shows the network topology. Host A1 and Host A2 are in Department A,
while Host B1 and Host B2 are in Department B. Switch 1 and Switch 2 are located in two
different places. Host A1 and Host B1 are connected to port 1/0/2 and port 1/0/3 on Switch
1 respectively, while Host A2 and Host B2 are connected to port 1/0/6 and port 1/0/7 on
Switch 2 respectively. Port 1/0/4 on Switch 1 is connected to port 1/0/8 on Switch 2.
Figure 3-1 Network Topology
Demonstrated with T1600G-28TS, the following sections provide configuration procedure
in two ways: using the GUI and using the CLI.
3.4

Using the GUI

The configurations of Switch 1 and Switch 2 are similar. The following introductions take
Switch 1 as an example.
1) Choose the menu L2 FEATURES > VLAN > 802.1Q VLAN > VLAN Config and
click
Department_A. Add port 1/0/2 as an untagged port and port 1/0/4 as a tagged port to
VLAN 10. Click Create.
Host A1
Gi1/0/2
Switch 1
Gi1/0/3
Host B1
to load the following page. Create VLAN 10 with the description of
VLAN 10
Host A2
Gi1/0/6
Gi1/0/8
Gi1/0/4
Gi1/0/7
VLAN 20
Host B2
Configuration Example
Switch 2
User Guide 145