Ipv6 Static Routing Configuration; Using The Gui; Using The Cli - TP-Link T1600G-52TS User Manual

Configuring Routing
3

IPv6 Static Routing Configuration

3.1

Using the GUI

Choose the menu L3 FEATURES > Static Routing > IPv6 Static Routing > IPv6 Static
Routing Table and click
Figure 3-1 Configuring the IPv6 Static Routing
Configure the corresponding parameters to add an IPv6 static routing entry. Then click
Create.
IPv6 Address
Prefix Length
Next Hop
Distance
3.2

Using the CLI

Follow these steps to enable IPv6 routing function and create an IPv6 static route.
to load the following page.
Specify the destination IPv6 address of the packets.
Specify the prefix length of the IPv6 address.
Specify the IPv6 gateway address to which the packet should be sent next.
Specify the administrative distance, which is the trust rating of a routing entry. A
higher value means a lower trust rating. Among the routes to the same destination,
the route with the lowest distance value will be recorded in the IPv6 routing table.
The valid value ranges from 1 to 255 and the default value is 1
IPv6 Static Routing Configuration
User Guide 420