Using The Cli; Adding Static Mac Address Entries - TP-Link T1600G-52TS User Manual

Managing MAC Address Table
Choose the menu L2 FEATURES > Switching > MAC Address > Address Table and click
to load the following page.
Figure 2-5 Viewing Address Table Entries
2.2

Using the CLI

2.2.1 Adding Static MAC Address Entries

Follow these steps to add static MAC address entries:
Step 1 configure
Enter global configuration mode.
Step 2 mac address-table static mac-addr vid vid interface { fastEthernet port | gigabitEthernet
port | ten-gigabitEthernet port }
Bind the MAC address, VLAN and port together to add a static address to the VLAN.
mac-addr
specified VLAN are forwarded to the specified port. The format is xx:xx:xx:xx:xx:xx, for example,
00:00:00:00:00:01.
vid
port:
must belong to the specified VLAN.
: Enter the MAC address, and packets with this destination address received in the
: Specify an existing VLAN in which packets with the specific MAC address are received.
Specify a port to which packets with the specific MAC address are forwarded. The port
MAC Address Configurations
User Guide 130