Configuring Mld Snooping For Ports; Configuring Hosts To Statically Join A Group - TP-Link T1600G-52TS User Manual

Configuring Layer 2 Multicast

3.1.3 Configuring MLD Snooping for Ports

Choose the menu L2 FEATURES > Multicast > MLD Snooping > Port Config to load the
following page.
Figure 3-3 Configure MLD Snooping for Ports
Follow these steps to configure MLD Snooping for ports:
1) Enable MLD Snooping for the port and enable Fast Leave if there is only one receiver
connected to the port.
MLD Snooping
Fast Leave
LAG
2) Click Apply.

3.1.4 Configuring Hosts to Statically Join a Group

Hosts or Layer 2 ports normally join multicast groups dynamically, but you can also
configure hosts to statically join a group.
Enable or disable MLD Snooping for the port.
Enable or disable Fast Leave for the port.
Fast Leave can be enabled on a per-port basis or per-VLAN basis. When enabled
on a per-port basis, the switch will remove the port from the corresponding
multicast group of all VLANs before forwarding the done message to the querier.
You should only use Fast Leave for a port when there is a single receiver
connected to the port. For more details about Fast Leave, see
MLD Snooping for VLANs.
Displays the LAG the port belongs to.
MLD Snooping Configuration
3.1.2 Configuring
User Guide 232