Using The Cli; Configuring The Nms Host - TP-Link T1600G-52TS User Manual

Configuring SNMP & RMON
PoE
IP-MAC Binding
IP Duplicate
DHCP Filter
ACL Counter
2) Click Apply.
3.2

Using the CLI

3.2.1 Configuring the NMS Host

Configure parameters of the NMS host and packet handling mechanism.
Step 1
Only for products that support PoE. The trap includes the following sub-traps:
Over-max-pwr-budget: Triggered when the total power required by the
connected PDs exceeds the maximum power the PoE switch can supply.
Port-pwr-change: Triggered when a port starts to supply power or stops
supplying power.
Port-pwr-deny: Triggered when the switch powers off PDs on low-priority
PoE ports. The switch powers off them to ensure stable running of the other
PDs when the total power required by the connected PDs exceeds the
system power limit.
Port-pwr-over-30w: Triggered when the power required by the connected
PD exceeds 30 watts.
Port-pwr-overload: Triggered when the power required by the connected PD
exceeds the maximum power the port can supply.
Port-short-circuit: Triggered when a short circuit is detected on a port.
Thermal-shutdown: Triggered when the PSE chip overheats. The switch will
stop supplying power in this case.
Triggered in the following two situations: the ARP Inspection feature is
enabled and the switch receives an illegal ARP packet; or the IPv4 Source
Guard feature is enabled and the switch receives an illegal IP packet.
Triggered when the switch detects an IP conflict.
Triggered when the DHCPv4 Filter feature is enabled and the switch receives
DHCP packets from an illegal DHCP server.
Monitors matched ACL information, including the matched ACL ID, rule ID
and the number of the matched packets. With both this trap and the Logging
feature in the ACL rule settings enabled, the switch will check the matched
ACL information every five minutes and send SNMP traps if there is any
updated information.
configure
Enter Global Configuration Mode.
Notification Configurations
User Guide 873