Configuring The Port - TP-Link T1600G-52TS User Manual

Configuring 802.1Q VLAN
Acceptable frame type: All
Ingress Checking: Enable
Member in LAG: N/A
Link Type: General
Member in VLAN:
Vlan Name
---- -----------
1 System-VLAN
2 RD
Switch(config-if)#end
Switch#copy running-config startup-config

2.2.3 Configuring the Port

Follow these steps to configure the port:
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Egress-rule
-----------
Untagged
Tagged
configure
Enter global configuration mode.
interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list |
port-channel port-channel-id | range port-channel port-channel-list }
Enter interface configuration mode.
switchport pvid vlan-id
Configure the PVID of the port(s). By default, it is 1.
vlan-id : The default VLAN ID of the port with the values between 1 and 4094.
switchport check ingress
Enable or disable Ingress Checking. With this function enabled, the port will accept the
packet of which the VLAN ID is in the port's VLAN list and discard others. With this function
disabled, the port will forward the packet directly.
switchport acceptable frame {all | tagged}
Select the acceptable frame type for the port and the port will perform this operation before
Ingress Checking.
all: The port will accept both the tagged packets and the untagged packets.
tagged: The port will accept the tagged packets only.
end
Return to privileged EXEC mode.
copy running-config startup-config
Save the settings in the configuration file.
802.1Q VLAN Configuration
User Guide 142